×
Menu

Rotator (Gear Tab)

This section gives rotator control.
 
Rotator (Gear Tab)
 
1

Connect / Disconnect

1.  Connect / Disconnect
 
When you connect a rotator for the first time you will be asked to select the connection parameters by the standard ASCOM dialog. APT will remember your selection and when you click again on the “Connect” button it will use the previous settings automatically. If you want to change the connection parameters, use “Shift+Click” on the Connect button. Use Ctrl+Click to forget the selected connection parameters.
 
2

Settings

2. Settings
 
Opens the settings dialog of the ASCOM driver. If this action is not supported by the driver, use Shift+Click on Connect button and then click Properties in the driver selector dialog box.
 
3

Position

3.  Position
 
The current position reported by the driver.
 
4

Go to

4. Go to
 
Goes to the desired position. Enter the wanted degrees and click on GoTo.
 
Note: Using Shift+Click will synchronize rotator position with the entered value (if the ASCOM driver provides the functionality).
 
5

Move 10

5.  Move 10
 
Move the rotator by 10 degrees in one direction. The direction depends on the driver settings.
 
6

Move

6.  Move
 
Move the rotator by one degree in one direction. The direction depends on the driver settings.
 
7

Stop

7. Stop
 
Stops the running movement.
 
8

Move

8. Move
 
Move the rotator by one degree in the opposite direction. The direction depends on the driver settings.
 
9

Move 10

9. Move 10
 
Move the rotator by 10 degrees in the opposite direction. The direction depends on the driver settings.